Aqara Cube T1 Pro: Zigbee2MQTT Setup in Home Assistant
Pair the Aqara Cube T1 Pro to Zigbee2MQTT without an Aqara hub, set scene vs. action mode, and build automations in Home Assistant. No cloud required.
~/archive $ ls -la
Archive
Setup Guides
Setup guides
-
-
Aqara Vibration Sensor (DJT11LM): Local Setup via Zigbee2MQTT
Pair the Aqara DJT11LM vibration sensor to Zigbee2MQTT — no hub, no cloud. Pairing, sensitivity tuning, and automations for Home Assistant.
-
Aqara Door Sensor T1 + Home Assistant: Local Setup Guide
Set up the Aqara Door and Window Sensor T1 (MCCGQ12LM) in Home Assistant without the Aqara cloud. Covers Zigbee2MQTT and ZHA, model variants, battery quirks, and automations.
-
Aqara Hub M2 + Home Assistant: Full Local Control, No Cloud
Set up Aqara Hub M2 with Home Assistant using HomeKit Controller — all local, no cloud hop, no Aqara account needed after initial setup.
-
Aqara Wireless Mini Switch (WXKG11LM): Pair with Zigbee2MQTT and Build Home Assistant Automations Without the Aqara Hub
The Aqara Wireless Mini Switch is a CR2032-powered Zigbee button that fits in a shirt pocket and sticks anywhere with double-sided tape. Single press,
-
Aqara FP1E Presence Sensor: Full Local Setup with Zigbee2MQTT and Home Assistant
The Aqara FP1E is a mmWave presence sensor that runs entirely over Zigbee. No Aqara hub required — pair with Zigbee2MQTT for 100% local presence detection in Home Assistant.
-
Aqara Roller Shade Driver E1: Complete Home Assistant Local Setup Guide
The Aqara Roller Shade Driver E1 is one of the cheapest smart blind motors that works 100% locally with Home Assistant — no hub, no Aqara account, no cloud. But the calibration process is counterintuitive if you've never done it before.
-
Aqara T1 Temperature & Humidity Sensor (WSDCGQ12LM): Home Assistant Zigbee Setup Guide
The Aqara Temperature and Humidity Sensor T1 reports temperature, relative humidity, and atmospheric pressure over Zigbee. Pair it directly with a Home Assistant coordinator using Zigbee2MQTT or ZHA, and you can keep those readings and your local automations under your own control. This guide covers identifying the model, pairing through either integration, checking the readings,…
-
Aqara SP-EUC01 with Zigbee2MQTT: Full Local Power Monitoring in Home Assistant
The Aqara SP-EUC01 gives Home Assistant local switching and energy readings through Zigbee2MQTT. It uses Zigbee rather than Wi-Fi, so the plug does not need an Aqara account or an IP connection to the vendor. Below are the pairing steps, metering entities, Energy dashboard setup, and two automation examples. The troubleshooting section also covers a…
-
Aqara G2H Pro: Local Camera Stream in Home Assistant (No Cloud, go2rtc + Frigate)
The Aqara Camera Hub G2H Pro combines a 1080p indoor camera with an Aqara Zigbee hub. You can bring its HomeKit video into a local go2rtc and Frigate setup, but the RTSP address in that arrangement belongs to go2rtc, not the camera. This guide follows the practical route: provision the camera’s Wi-Fi, pair it to…